本帖最后由 至尊红颜 于 2016-9-20 10:38 编辑
这款小巧精致的路由器有4个LAN口1个wan口,参看以下外观截图
硬件配置:
System-On-Chip MediaTek MT7621AT
NAND FLASH 256M
MEMORY 256M
WLAN 2.4G -
WLAN 5G -
USB ports -
官方固件下载地址:
https://dl.ubnt.com/firmwares/edgemax/v1.9.0/ER-e50.v1.9.0.4901118.tar
官方固件有hw_nat
官方分区表:
Creating 7 MTD partitions on "MT7621-NAND":
0x000000000000-0x00000ff80000 : "ALL"
0x000000000000-0x000000080000 : "Bootloader"
0x000000080000-0x0000000e0000 : "Config"
0x0000000e0000-0x000000140000 : "eeprom"
0x000000140000-0x000000440000 : "Kernel"
0x000000440000-0x000000740000 : "Kernel2"
0x000000740000-0x00000ff00000 : "RootFS"
OpenWrt Upgrade URL:
https://downloads.openwrt.org/snapshots/trunk/ramips/mt7621/openwrt-ramips-mt7621-ubnt-erx-squashfs-sysupgrade.tar
openwrt没有hw_nat,没有开源驱动
OP 分区表:
6 ofpart partitions found on MTD device MT7621-NAND
Creating 6 MTD partitions on "MT7621-NAND":
0x000000000000-0x000000080000 : "u-boot"
0x000000080000-0x0000000e0000 : "u-boot-env"
0x0000000e0000-0x000000140000 : "factory"
0x000000140000-0x000000440000 : "kernel1"
0x000000440000-0x000000740000 : "kernel2"
0x000000740000-0x00000ff00000 : "ubi"
不要随意乱动factory分区,尤其是分区擦写时,参看以下截图:
官方固件刷OP firmware起不来肿么办,不要慌张,只要官方uboot还在就问题不大, tftp刷机:
i. 上TTL串口,参看inner_side截图
ii. 选择uboot启动方式,可以是1或是2,设置tftp client和server IP 地址,注意device是router
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP.
3: Boot system code via Flash (default).
4: Entr boot command line interface.
7: Load Boot Loader code then write to Flash via Serial.
9: Load Boot Loader code then write to Flash via TFTP.
default: 3 4
You choosed 1
0
1: System Load Linux to SDRAM via TFTP.
Please Input new ones /or Ctrl-C to discard
Input device IP (172.16.3.212) ==:192.168.2.199
Input server IP (172.16.3.210) ==:192.168.2.104
Input Linux Kernel filename (vme50) ==
ubiquiti路由器
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有账号?立即注册





查看全部评分